Avaya Definity SI - Page 2447

TBRI-BD (TN2185 ISDN Trunk-Side BRI)
Issue 4 May 2002
10-1661 555-233-123
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of
5 times.
1-10 FAIL The circuit pack is still detecting errors of this type. The error
code indicates the value of the on-board error counter.
1. Retry the command at 1-minute intervals a maximum of
5 times.
2. If the test continues to fail, verify the validity of the
Packet Bus. Run the Packet Bus maintenance test with
the test pkt P long command. If any Packet Bus tests
fail, refer to the “PKT-BUS (Packet Bus)” section for
recommended repair procedures.
3. If the Packet Bus test passes, check the validity of the
circuit pack. Execute a test that involves data
transmission onto the Packet Bus. For example, the test
port PCSSpp command may use the connectivity tests
of the BRI-PORT maintenance object. If the test fails,
refer to the repair procedures; otherwise, proceed to the
next step.
4. Other circuit packs on the Packet Bus may be causing of
the parity error. Use the display errors command to
check the Error Log for alarmed other circuit packs.
Resolve any alarms for other circuit packs as well. Rerun
the LAN Receive Parity Error Counter Test (#595).
PASS No errors detected.
Table 10-609. TEST #595 LAN Receive Parity Error Counter Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page