Maintenance Object Repair Procedures
555-233-123
10-1676 Issue 4 May 2002
2000 ABORT Response to the test was not received from the BRI-LINE
circuit pack within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit
pack with busyout board PCSS and reset board PCSS
if the other ports on the board are not in use.
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2103 ABORT The system could not make the conference connection for the
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1, 2 FAIL The TDM Looparound failed on one of the channels.
■ Error Code 1 — TDM Loop Around Test failed on
B1.
■ Error Code 2 — TDM Loop Around Test failed on
B2.
7, 8 FAIL The Conference Circuit Tests failed on a B-channel.
■ Error Code 7 — test failed on B1
■ Error Code 8 — test failed on B2.
1. If the test fails repeatedly, attempt to reset the circuit pack
with busyout board PCSS and reset board PCSS if the
other ports on the board are not in use.
2. If the test fails again, replace the circuit pack.
PASS The BRI Port Local TDM Loop Around Test passed.
Table 10-615. TEST #619 BRI Port Local TDM Loop Around — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
