TBRI-TRK (TN2185 ISDN Trunk-Side BRI)
Issue 4 May 2002
10-1695 555-233-123
2036
2037
ABORT Internal system error
1. Follow the recommendation for ABORT code 2012.
2038
2039
ABORT A problem occurred while trying to read the test data.
1. Wait one minute and then try again.
2. If the test aborts again in the same manner, there is a
serious internal problem. If so, escalate the problem.
2040 ABORT Internal system error
1. Follow the recommendations for ABORT code 2012.
2041 ABORT The call has timed out, perhaps because of a lack of system
resources.
1. Follow the recommendations for ABORT code 2035.
2066 ABORT Could not establish test call.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2067 ABORT The call has timed out, perhaps because of a lack of system
resources.
1. Follow the recommendations for ABORT code 2035.
2074 ABORT Bit and Block Error query failed.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, there may be a serious
internal problem with M/T-DIG (Maintenance/Test Digital
Port). If this is the case, refer to the M/T-DIG
(Maintenance/Test Digital Port) Maintenance
documentation.
2075 ABORT Internal system error
1. Follow the recommendations for ABORT code 2012.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Table 10-624. TEST #258 ISDN TEST Call — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
