Maintenance Object Repair Procedures
555-233-123
10-1694 Issue 4 May 2002
1116 ABORT The switch could not appropriately change the ISDN service
state.
1. Determine if a call is active on this ISDN Trunk-side BRI
trunk (use the status trunk command).
2. If not, check the Error and Alarm Logs for problems with
this TBRI-TRK MO.
1117 ABORT ISDN B-channel maintenance message is already
outstanding.
1. Wait two minutes, then try again.
1118 ABORT Far-end of ISDN trunk is not administered.
1. Check the administration of the far-end ISDN trunk.
2. Issue the status trunk command and try the test again.
1119 ABORT The test call was aborted due to a normal call attempt on this
trunk. The test call is performed only if the trunk is idle.
1. Either wait for the normal call to terminate normally, or
force it to be dropped by using the busyout trunk
command.
1120 ABORT The ISDN Trunk-side BRI trunk is in the ISDN
out-of-service/far-end state.
1. Try to change the service state via Test #256 (Service
State Audit Test). Then retry this test. However, the trunk
may be in the out-of-service/far-end state due to
problems at the far-end switch. If that is the case, no
remedial action can be taken at this end.
1122 ABORT There is no test line number for the far-end switch.
1. Check the Trunk Group Administration form.
1123 ABORT There is no Feature Access Code administration for this
Facility Test.
1. Check the Dial Plan and Feature Administration forms.
2012
None
2000
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
2035 ABORT The call has timed out, perhaps because of a lack of system
resources.
1. Wait 1 minute and try again.
Table 10-624. TEST #258 ISDN TEST Call — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
