TSC-ADM (Administered Temporary Signaling
Connections)
Issue 4 May 2002
10-1823 555-233-123
1113 ABORT The D-channel is out-of-service.
1. Refer to the ISDN-LNK (ISDN-PRI Signaling Link Port)
Maintenance documentation.
1145 ABORT There is congestion in the network.
1. Issue the status tsc-administered command at 1-minute
intervals a maximum of 5 times.
2. If the congestion does not clear, disable and enable the
Administered TSC via change sig-group <group>. To
disable the Administered TSC, display the
(administration) Signaling Group Form via change
sig-group <group> where <group> refers to the number
of the signaling group under which the suspect TSC is
administered. Change the Enable field to “n.” To enable
the ADMTSC, change the “Enable” field to “y.”
3. If the congestion still does not clear, check other nodes in
the network. If congestion persists, then escalate the
problem.
1146 ABORT The congestion just occurred in the network.
1. Issue the status tsc-administered command at 1-minute
intervals a maximum of three times.
2. If congestion does not clear, disable and enable the
Administered TSC via the change sig-group <group>
command. To disable the Administered TSC, display the
(administration) Signaling Group Form via the change
sig-group <group> command where <group> refers to
the number of the signaling group under which the
suspect TSC is administered. Change the Enable field to
"n." To enable the ADMTSC, change the "Enable" field to
"y."
3. If congestion still does not clear, check the other nodes in
the network. If the congestion persists, escalate the
problem.
Table 10-663. TEST #604 TSC Heartbeat Inquiry Test
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
