Avaya Definity SI - Page 2736

Maintenance Object Repair Procedures
555-233-123
10-1950 Issue 4 May 2002
PPE/LANBIC Receive Parity Error Counter Test
(#595)
This test is non-destructive. When the VAL circuit pack detects a parity error with
a received frame, it increments the PPE/LANBIC Receive Parity error counter.
This test reads and clears the counter, and can verify repair of the problem.
Errors can indicate a problem with:
■ This circuit pack
■ A packet bus
■ Another circuit pack on the bus
Table 10-695. TEST #595 PPE/LANBIC Receive Parity Error Counter Test
Error
Code
Te s t
Result Description/Recommendation
2000 ABORT Did not receive circuit pack test response within the allowable
time period.
Retry command at 1-minute intervals, up to 5 times.
If the problem persists, reset the circuit pack (reset board
UUCSS).
If the problem persists, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run test.
2500 ABORT Internal system error.
Retry the command at 1-minute intervals, up to 5 times.
If the problem persists, escalate the problem.
1-10 FAIL Circuit pack detects parity errors. The Error Code indicates the
value of the on-board error counter.
Retry the command at 1-minute intervals, up to 5 times.
If the test continues to fail, execute the Packet Interface Test
(#598) (test board UUCSS).
If Packet Interface Test (#598) fails, see repair procedures for
Test (#598).
PASS Circuit pack detects no errors.
Continued on next page