VAL-PT (Voice Announcements over LAN Packet/Port)
Issue 4 May 2002
10-1967 555-233-123
Table 10-705. TEST #1285 TDM Looparound Test
Error
Code
Te s t
Result Description/Recommendation
1000 ABORT The port is in use.
Retry the command when the port is idle. You can force the
port to the idle state with the busyout port UUCSS command.
Escalate if the problem persists.
This command is destructive, tearing down all calls and links
using the port.
1002 ABORT No TDM bus timeslots available for the test.
Retry the command at 1-minute intervals, up to 5 times.
Escalate if the problem persists.
1003 ABORT No more tone receivers idle for use in this test.
Retry the command at 1-minute intervals, up to 5 times.
Escalate if the problem persists.
2000 ABORT Did not receive circuit pack test response within the allowable
time period.
If this problem persists, reset the circuit pack (busyout board
UUCSS, reset board UUCSS, and release board UUCSS).
Repeat the test.
If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
Retry the command at 1-minute intervals, up to 3 times.
Escalate if the problem persists.
2100 ABORT Could not allocate the necessary system resources to run test.
Retry the command at 1-minute intervals, up to 5 times.
Escalate if the problem persists.
FAIL Received tones do not match transmitted tones.
Retry command at 1-minute intervals, up to 3 times.
If the problem persists, refer to TDM-BUS, Tone Generator,
and Tone Receiver repair procedures.
If the problem persists, reset the board (busyout board
UUCSS, reset board UUCSS, and release board UUCSS).
Repeat the test.
If the problem persists, replace the circuit pack.
PASS Port connections across the TDM bus function properly.
Continued on next page
To Next Page
Loading...
