Maintenance Object Repair Procedures
555-233-123
10-2014 Issue 4 May 2002
be reset via reset board PCSS command. The reset command executes this
test.
Table 10-724. TEST #53 SAKI Sanity Test
Error
Code
Te s t
Result Description/Recommendation
none ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1005 ABORT Wrong circuit pack configuration to run this test. This error
applies only to DS1 interface circuit packs. It means the DS1
interface circuit pack is providing timing for the system and,
therefore, it cannot be reset without major system disruptions.
1. If the circuit pack needs to be reset, set synchronization to
another DS1 interface circuit pack or the Tone-Clock circuit
pack and try again. Refer to SYNC (Synchronization)
Maintenance documentation.
1015 ABORT Port is not out-of-service.
1. Busy out the circuit pack.
2. Execute command again.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The circuit pack initializes correctly.
1. Run the Short Test Sequence.
any NO
BOARD
This is normal if the test is being done when (a) the circuit pack
is not physically in the system or (b) the system is booting up.
Otherwise, there is some inconsistency between the physical
configuration and the data kept in the system.
1. Verify that the circuit pack is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals for a maximum of
5 times.
Continued on next page
To Next Page
Loading...
