Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-42 Issue 4 May 2002
Field descriptions
SPE OPTIONAL BOARDS section
Packet
Intfl1
Identifies the presence of Packet Interface 1 (y for si).
Packet
Intfl2
Identifies the presence of Packet Interface 2 (y for si). Default is n.
Bus Bridge
The location of the C-LAN circuit pack performing the bus bridge
functionality when the packet bus is activated. Enter 5-character circuit
pack number (CCcss, where CC = cabinet number 1-3, c = carrier
A-E, ss = slot number 0-20). Default is blank.
Inter-Boar
d Link
Timeslot
Pt0
The number of timeslots to be used for port 0 on the Inter-Board Link.
Displays only if the switch type is csi and the
Packet Intf2 field is
y. Enter the number of timeslots (1-9) to be used by this Inter-Board
Link port. Default is 6.
Inter-Boar
d Link
Timeslot
Pt1
The number of timeslots to be used for port 10 on the Inter-Board Link.
Displays only if switch model type is csi and the
Packet Intf2
field is y. Enter the number of timeslots (1-3) to be used by this
Inter-Board Link port. Default is 1.
Inter-Boar
d Link
Timeslot
Pt2
The number of timeslots to be used for port 2 on the Inter-Board Link.
Displays only if switch model type is csi and the
Packet Intf2
field is y. Enter the number of timeslots (1-3) to be used by this
Inter-Board Link port. Default is 1.
Page 2 of 3
MAINTENANCE-RELATED SYSTEM PARAMETERS
MINIMUM MAINTENANCE THRESHOLDS ( Before Notification )
TTRs: 4
CPTRs: 1 Call Classifier Ports: 0
MMIs: 0
VCs: 0
TERMINATING TRUNK TRANSMISSION TEST (Extension)
Test Type 100: Test Type 102: Test Type 105:
ISDN MAINTENANCE
ISDN-PRI TEST CALL Extension: _____ ISDN BRI Service SPID: _____
DS1 MAINTENANCE
DSO Loop-Around Test Call Extension: _____
SPE OPTIONAL BOARDS
Packet Intf1? y
Packet Intf2? _
Bus Bridge: ____ Inter-Board Link Timeslots Pt0: _ Pt1: _ Pt2: _
To Next Page
Loading...
