test tdm
Issue 4 May 2002
A-147 555-233-123
test tdm
Help Messages
If the system technician presses HELP after entering “test tdm” the following
message appears:
Enter ’port-network’, port network number (1-3),
[’long’ or ’short’], [’repeat’ (1-100) or ’clear’], [’schedule’]
Error Messages
If the technician does not enter all digits for the port-network number, the following
message appears:
Entry must be all digits
If the technician enters a Port Network number that is not administered, the
following message appears:
Port Network number not assigned
If the port network on which the desired TDM bus resides is unavailable, the
following message appears:
EPN is not available
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
