list measurements ip codec
Issue 4 May 2002
8-169555-233-123
Services personnel who wish to estimate the amount of IP traffic used on IP
trunks versus IP stations can compare the above report with the lines of the list
measurements trunk-group and list performance trunk-group, and list
measurements outage-trunk and monitor traffic trunk-groups reports which
correspond to IP trunk groups. Note that it is required that the switch does not
have mixed IP and non-IP ports in a single trunk group.
The following screen shows Measurements IP CODEC yesterday-peak - Page 1.
G.711 Out
of Reg peg
The total number of times an IP media processor port was needed in
the region for a G.711 call, but was successfully allocated to a
resource in another region. Out of Region does not include denials. If
“Network regions are interconnected” is “n”, then Out of Region is 0.
Range: 0-65535.
G.723/9
Usage
(ERL)
Usage in Erlangs of G.723 or G.729 codecs during the measurement
interval. Includes time that the voice channels are on a call. Use is
measured from the time the voice channel is allocated until it is
released. Calculated by:
(Total Call Seconds) / 3600 where Total Call Seconds is a sum of the
following:
total time (in seconds) that a G.723 or G.729 resource on a Medpro is
in use
twice the total time (in seconds) that a G.723 or G.729 resource on an
IP Media Processor is in use
Range: 0-9999.
G.723/9 In
Reg peg
Total number of times an IP media processor port in the region was
allocated to a G.723 or G.729 call. Range: 0-65535.
G.723/9
Out of Reg
peg
The total number of times an IP media processor port was needed in
the region for a G.723 or G.729 call, but was successfully allocated to
a resource in another region. Out of Region does not include denials. If
“Network regions are interconnected” is “n”, then Out of Region is 0.
Range: 0-65535.
list measurements ip codec summary yesterday-peak Page 1
Switch Name: Date: 5:27 pm WED MAR 26, 1992
IP CODEC RESOURCE SUMMARY REPORT
G711 G723/9
--------------------- -------------------------
Meas DSP Usage In Reg Out of Usage In Reg Out of
Hour Region Rscs (Erl) peg Reg peg (Erl) peg Reg peg
0400 1 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
0300 2 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
0600 44 xxxx xxxx.x xxxxx xxxxx xxxx.x xxxxx xxxxx
Command successfully completed
To Next Page
Loading...
