status conference
Issue 4 May 2002
8-333555-233-123
Drop
Reason
(cont’d)
Endpoint Clearing received from DS1. The endpoint causes the
disconnect. The endpoint notifies the MCU that it intends to
disconnect.
Far-end Clearing received from DS1. The network or endpoint cause
the disconnect.
“Handshake” = Framing is not located or is lost for over 40 seconds
and the endpoint disconnects. (The endpoint cannot complete
initialization due to problems with finding Frame Alignment Signal
(FAS), Multi Frame Alignment (MFA) and getting a corrected coded
cap-set.)
“IDtimeout” = The H.320 sends three unsuccessful responses to the
MCU regarding the UIN/password Query. Timeout periods exist for
each period.
“Internal” = MCU cannot allocate the necessary trunk resources to
route the dial-out call for the specified dial-numbers. This problem
can be associated with routing patterns or trunk associated
translations, or it can indicate insufficient trunk resources.
“Network” = Clearing received from DS1. The network causes the
disconnect. The endpoint with disconnect notification capability
disconnects without notifying the MCU.
“Not-MCU” = The dial-out destination number(s) of the “CAS”
extension terminates to a number that is not a dial-in cascade MCU
extension.
“No-ring” = Calls are up for 30 seconds without ringing.
“Reorder” = The MCU CPTR resources detects that no network
trunks are available to place the call. See “Dial-out” for a description
of CPTR usage.
To Next Page
Loading...
