test hardware-group
Issue 4 May 2002
8-445555-233-123
Output
The following example shows the output for the test hardware-group system
command and assumes that the board in port network 1, carrier c, slot 7 is an
analog board with three administered ports and test sequence repeat = 3.
Responses to this command running in the foreground display on a test-by-test
basis with one line of data for each test result.
TN722B DS1 Tie Trunk TN2146 Direct Inward Dialing Trunk
TN726B Data Line TN2147 Central Office Trunk
TN742 8 port Analog Line TN2149 Analog Line
TN2180 16 port Analog line
SPE-interchange?
Allow for planned interchange of duplicated SPEs and
subsequent testing of both the active and standby SPEs.
Table 8-16. Test of ‘all ports’ option for the following boards: — Continued
Board
Number Description
Board
Number Description
Continued on next page
test hardware-group system
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
01C07 ANL-BD 51 PASS
01C07 ANL-BD 52 PASS
01C0703 ANL-LINE 35 PASS
01C0702 ANL-LINE 35 PASS
01C0703 ANL-LINE 48 PASS
01C0701 ANL-LINE 35 PASS
01C0702 ANL-LINE 48 PASS
01C0703 ANL-LINE 36 PASS
01C0702 ANL-LINE 36 PASS
01C0701 ANL-LINE 48 PASS
01C0701 ANL-LINE 36 PASS
Testing system, 11070 of 12300 (90%) MOs tested for repetition 1
To Next Page
Loading...
