traceroute
Issue 4 May 2002
8-497555-233-123
NOTE:
The default DiffServ and 802.1p/Q parameters downloaded to a IP Media
Processor board will be used in the execution of ping and traceroute
commands which are sourced from that IP Media Processor. By convention,
the recipient of a ping will reply with the same QoS value found in the
received packet, hence the measurements reported should reflect the
behavior of the type of packets sent. IP Media Processor-sourced pings
should reflect audio transport performance and C-LAN-sourced pings
should reflect control information transport performance.
Output
The following shows an example output for the C-LAN traceroute command. For
Medpro boards, the clan-port (1-17) qualifier does not appear.
Action/
Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
traceroute ip-address
board
where IP address is
www.xxx.yyy.zzz
Cabinet-carrier-slot
address of the C-LAN
circuit pack
Examples:
traceroute ip-address
123.4.56.789
traceroute board 1C14
init
inads
craft
customer
Primary None
source an endpoint’s virtual port
ID
Example:
trace-route ip-address
106.245.27.205 source
S00015
traceroute ip-address 135.9.1.22 board 1C14 clan port (1-17)
TRACE ROUTE RESULTS
Hop Time(ms) IP Address
0 from address 135.9.1.22
01 03,10,05 134.9.14.23
02 11,20,03 134.9.5.103
03 22,01,25 106.245.27.205
04 22,01,25 !N 106.245.27.205
To Next Page
Loading...
