ANL-24-L (24-Port Analog Line)
Issue 4 May 2002
10-55 555-233-123
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port’s message lamp state (if it has one) and
translations with information in the software.
Table 10-21. Test #36 Station Status and Translation Audits and Updates
Error
Code
Te s t
Result
Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1004 ABORT The port was seized by a valid call during the test. The test has
been aborted.
1. Use the display port PCSSpp command to determine the
station extension.
2. Use the status station command to determine the service
state of the port.
3. If the port is in use, wait until port is idle and retry the
command at 1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test
may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem
pool member or Music On Hold).
1006 ABORT This port has been busied out by command, or taken
out-of-service by the failure of the NPE Crosstalk Test.
1. Look in the Error Log for error type 18 (port busied out) for
this port. If this error is present, release the port with the
release station extension command, and run the test
again.
2. Check the Error Log for error type 1025 (NPE crosstalk test
failed) for this port. If this error is present, investigate the
errors associated with the NPE Crosstalk Test #6.
3. Make sure that the terminal is connected and in service, and
then retest.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page
To Next Page
Loading...
