ANL-24-L (24-Port Analog Line)
Issue 4 May 2002
10-61 555-233-123
1004 ABORT The port was seized by a valid call during the test. The test
has been aborted.
1. Use the display port PCSSpp command to determine the
station extension.
2. Use the status station command to determine the
service state of the port.
3. If the port is in use, wait until the port is idle and retry the
command at 1-minute intervals a maximum of 5 times.
1005 ABORT This test is not run on ports administered as External Alert,
Announcement or combined modem pool ports. This error can
be ignored.
1018 ABORT The test has been disabled by administration. The default for
the
Test field on the station form is y. Determine why this
field has been set to
n on this station (this may be due to the
ringing application test 48, that can be customer or terminal
disturbing).
1. To enable the test for a particular station being tested,
enter change station extension and set the
Test? field
on the station from
n to y.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test. This could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Table 10-23. TEST #161 Looparound Test — Continued
Error
Code
Te s t
Result
Description/Recommendation
Continued on next page
To Next Page
Loading...
