ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon
Analog Line)
Issue 4 May 2002
10-103 555-233-123
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to “TTR-LEV (TTR Level)” Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to “TONE-PT (Tone Generator)” Maintenance
documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
1004 ABORT The port has been seized for a valid call during the conference
or noise test. Use the status station command to determine
when the port is available for testing.
1. If the circuit pack is a TN742 with vintage 10 or less, this
test is not valid. Otherwise, proceed with #2.
2. When the port is available for testing, retry the command
at 1-minute intervals, a maximum of 5 times.
3. If the test continues to abort and the port is not in use,
escalate the problem.
1005 ABORT The test was aborted due to a configuration problem. This
code will result under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to
terminal equipment other than a voice terminal (for
example, the modem pool member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13,14 and 15
— TN769 vintages 3,4 and 5
1018 ABORT Test disabled via administration. The default for the 'Test' field
on the 'Station' form is 'y'; thus, you may want to determine
why this field has been set to 'n' on this station (this may be
due to the ringing application test 48, which can be customer
or terminal disturbing).
1. To enable the test for a particular station, enter change
station extension and set the ‘Test?’ field on the ‘Station
Form’ to ‘y.’
Table 10-35. TEST #47 Loop Around and Conference Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
