ANN-PT (Announcement Port)
Issue 4 May 2002
10-165 555-233-123
140AY Channel Sanity Inquiry Test (#222)
The Angel keeps a sanity status bit for each of the 16 channels on the 140AY
device. This test queries the Angel to determine the status for a particular
channel. If a channel is insane, that implies that announcements cannot be played
back on that channel.
Table 10-54. TEST #222 140AY Channel Sanity Inquiry Test
Error
Code
Te s t
Result Description/Recommendation
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
ABORT Internal System Error.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, escalate the problem.
FAIL Test failed. Announcements cannot be played back over this
port.
1. Reset the circuit pack via the reset board PCSS
command and then run this test again. If the test continues
to fail, replace the circuit pack (see Warning).
2. If there are recurring alarms on this port caused by this
test failing, replace the circuit pack even if Step 1 works
(see Warning).
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. Refer to “General Notes” near the
beginning of this Maintenance procedure.
PASS Announcements can be played back over this port.
User-reported troubles on this pack should be investigated
using other port and circuit pack tests. Refer to ‘‘AN-LN-PT
(Analog Line Port)’’ for a description of the circuit pack tests.
Continued on next page
To Next Page
Loading...
