Maintenance Object Repair Procedures
555-233-123
10-188 Issue 4 May 2002
Table 10-61. TEST #621 Level 1 Status Inquiry
Error
Code
Te s t
Result Description/Recommendation
1187 ABORT The board, port, or station may have been busied-out by a
technician.
1. Look in the Error Log for Error Type 18 (port busied out)
for this port and ASAI-BD (board busied out). If this error
type is present for ASAI-PT only, then release the port
using the release port pp command and run the test
again. If the error is present for both ASAI-BD and
ASAI-PT, then release the board with the release port
PCSS command and run the test again.
NOTE:
When you release a port, you release all ports
associated with it. If certain ports still need to be busied
out, use the release port PCSSpp command to busy
them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5
times.
2000 ABORT Response was not received from the circuit pack within the
allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset
the circuit pack using the busyout board PCSS and
reset board PCSS commands.
2. If the test aborts again, replace the circuit pack.
Continued on next page
To Next Page
Loading...
