RX2540 M4 Upgrade and Maintenance Manual 119
Basic software procedures
For ATD logo and more information on Advanced Thermal Design (ATD),
see the operating manual of your server.
V CAUTION!
Please note that you can only set the ATD flag. Resetting the ATD flag
using the Chassis ID Prom Tool is not possible!
5.2.18 Configuring LAN teaming
Use ServerView Operations Manager to obtain more information on existing
LAN teams:
Ê In ServerView Operations Manager Single System View select System
Status from the Information/Operation menu.
Ê Under Network Interfaces select LAN Teaming.
Ê The Network Interfaces (Summary) overview shows all configured LAN
teams and their components. Choose a LAN team to display further details:
– LAN Team Properties: Properties of the selected LAN team
– LAN Team Statistics: Available statistics about the selected LAN team
I For more information, see the "ServerView Operations Manager - Server
Management" user guide.
5.2.18.1 After replacing/upgrading LAN controllers
Ê You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I For more information, see the relevant LAN driver manual.
5.2.18.2 After replacing a system board
I The following procedure must be done for each system board that is
replaced.
Ê Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
To Next Page
Loading...
