EasyManua.ls Logo

Fujitsu PRIMERGY RX2540 M4

Fujitsu PRIMERGY RX2540 M4
639 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
534 Upgrade and Maintenance Manual RX2540 M4
System board and components
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê "Getting access to the component" on page 58
16.6.4.2 Replacing the microSD card
Ê Remove the Dual microSD 64GB Enterprise, see section "Removing the
Dual microSD 64GB Enterprise" on page 529.
Ê Remove the defective microSD card from the Dual microSD 64GB
Enterprise. Proceed as described in the following:
Ê To eject the defective microSD card, gently push it in and then let go (see
figure 401 on page 532).
Ê Pull the microSD card straight out of its slot.
V CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
Ê With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see figure 402 on page 533).
Ê Install the Dual microSD 64GB Enterprise, see section "Installing the Dual
microSD 64GB Enterprise" on page 524.
16.6.4.3 Concluding steps
Ê If applicable "Installing the air duct" on page 89
Ê "Reassembling" on page 63
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70

Table of Contents

Other manuals for Fujitsu PRIMERGY RX2540 M4

Related product manuals