384 Upgrade and Maintenance Manual RX2540 M4
12.4 Main memory for LC
I For general information about the main memory, see chapter "Main
memory" on page 327.
12.4.1 Installing memory modules
12.4.1.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 91
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê "Getting access to the component" on page 58
Ê If applicable, remove the riser module, see section "Riser modules for
GPGPU cards (FL)" on page 82.
12.4.1.2 Preparing the memory modules
I Before installing new memory modules prepare the memory modules
with the adhesive memory pads.
The adhesive memory pads must be ordered separately.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver (for the riser module)
To Next Page
Loading...
