290 Upgrade and Maintenance Manual RX2540 M4
Expansion cards and backup units
9.9.6.3 Installing the new riser card
Ê Install the new riser card, see section "Installing the riser card" on page 73.
Ê Install the expansion card, see section "Installing an expansion card in a
riser module" on page 281.
Ê If applicable, install the riser module 1, see section "Installing the riser
module 1 (HL)" on page 75.
Ê If applicable, install the riser module 2, see section "Installing the riser
module 2 (HL)" on page 79.
9.9.6.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For the cable plan, see chapter "Appendix B" on page 573.
9.9.6.5 Connecting a FBU to the expansion card
Ê If applicable, connect an FBU cable to the expansion card, see section
"Installing the new TFM" on page 311.
9.9.6.6 Concluding steps
Ê "Reassembling" on page 63
Ê Connect all external cables to the replaced expansion cards.
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70
Ê "Enabling replaced components in the BIOS" on page 108
Ê If applicable,"Updating expansion card firmware" on page 100.
Ê "Resuming BitLocker functionality" on page 112
9.10 GPGPU cards in riser modules (FL)
I FL means cards with full length (312 mm).
To Next Page
Loading...
