510 Upgrade and Maintenance Manual RX2540 M4
System board and components
Figure 379: Removing the TPM spacer
Ê Using a pair of flat nose pliers, press together the hooks on the TPM spacer
(see arrows) and remove it from the system board.
I If the TPM is to be replaced, the TPM spacer may remain on the
system board.
Ê If applicable, install the OCP module, see section "Installing the OCP
module" on page 249.
Ê Install the system board, see section "Installing the new system board" on
page 540.
16.3.2.3 Concluding steps
Ê If applicable, install the riser module 1, see section "Handling riser modules"
on page 71.
Ê "Installing the fan holder" on page 234
Ê "Installing the air duct" on page 89
Ê "Reassembling" on page 63
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70
Ê "Resuming BitLocker functionality" on page 112
To Next Page
Loading...
