Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

RX2540 M4 Upgrade and Maintenance Manual 479
Front panel
14.7.3 Replacing the front VGA board
14.7.3.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 91
Ê "Locating the defective server" on page 53
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê "Getting access to the component" on page 58
Ê "Removing the fan holder" on page 233
14.7.3.2 Removing the front panel module
Ê Remove the front panel module, see section "Removing the front panel
module" on page 469.
14.7.3.3 Removing the front VGA board
Ê Remove the front VGA board, see section "Removing the front VGA board"
on page 477.
14.7.3.4 Installing the new front VGA board
Ê Install the new front VGA board, see section "Installing the front VGA board"
on page 476.
14.7.3.5 Installing the front panel module
Ê Install the front panel module, see section "Installing the front panel module"
on page 471.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: Phillips PH1 screw driver

Fujitsu PRIMERGY RX2540 M4 Specifications

General

Processor	Intel Xeon Scalable Processor Family
Form Factor	2U rack server
Chipset	Intel C621
Memory	Up to 3TB DDR4
Storage	Up to 24 x 2.5-inch SAS/SATA/NVMe drives or Up to 12 x 3.5-inch SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60 (with optional controller)
Expansion Slots	Up to 8x PCIe Gen3 slots
Power Supply	800W or 1200W (1+1 redundant)
Memory Type	DDR4
Management	iRMC S5 (Integrated Remote Management Controller)
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware