266 Upgrade and Maintenance Manual RX2540 M4
Expansion cards and backup units
Note on network settings recovery
I When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.5.3.1 Preliminary steps
Ê If applicable, "Note on network settings recovery" on page 266
Ê "Locating the defective server" on page 53
Ê "Suspending BitLocker functionality" on page 91
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê Remove all external cables from the expansion card to be replaced.
Ê "Getting access to the component" on page 58
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs, see section "Onboard indicators and controls" on page 551.
9.5.3.2 Removing an expansion card
Ê If applicable, "Removing an SFP+ transceiver module" on page 244.
Ê "Removing an expansion card" on page 263
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board, see section "Removing a slot bracket" on page 240.
9.5.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 239.
Ê "Installing an expansion card" on page 254.
Ê If applicable, "Installing SFP+ transceiver modules" on page 241.
To Next Page
Loading...
