Fujitsu PRIMERGY RX2540 M4

388 Upgrade and Maintenance Manual RX2540 M4
Liquid cooling (LC)
12.4.3.1 Preliminary steps
Ê "Locating the defective server" on page 53
Ê "Suspending BitLocker functionality" on page 91
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê "Getting access to the component" on page 58
Ê If applicable, remove the riser module, see section "Riser modules for
GPGPU cards (FL)" on page 82.
12.4.3.2 Replacing a memory module
Ê Prepare the memory modules, see section "Preparing the memory modules"
on page 384.
Ê Remove the memory modules, see section "Removing a memory module"
on page 387.
Ê Install the memory modules, see section "Installing a memory module" on
page 385.
12.4.3.3 Concluding steps
Ê If applicable, install the riser module, see section "Riser modules for GPGPU
cards (FL)" on page 82.
Ê "Reassembling" on page 63
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70
Ê "Resetting the error status after replacing memory modules or CPUs" on
page 104
Ê "Enabling replaced components in the BIOS" on page 108
Ê "Verifying the memory mode" on page 108
Ê "Resuming BitLocker functionality" on page 112