516 Upgrade and Maintenance Manual RX2540 M4
System board and components
16.4.3.1 Preliminary steps
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê "Getting access to the component" on page 58
Ê If applicable, remove the riser module 1, see section "Handling riser
modules" on page 71.
16.4.3.2 Replacing the iRMC microSD card
Ê Remove the defective iRMC microSD card, see section "Removing the
iRMC microSD card" on page 514.
V CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new iRMC microSD card, see section "Installing the iRMC
microSD card" on page 513.
16.4.3.3 Concluding steps
Ê If applicable, install the riser module 1, see section "Handling riser modules"
on page 71.
Ê "Reassembling" on page 63
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70
To Next Page
Loading...
