188 Upgrade and Maintenance Manual RX2540 M4
Hard disk drives (HDD) and solid state drives (SSD)
7.4.8.1 Preliminary steps
Ê "Locating the defective server" on page 53
Ê "Locating the defective component" on page 54.
7.4.8.2 Removing a 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module, see section "Removing a 2.5-inch
HDD/SSD module" on page 186.
Ê If applicable, remove the HDD/SSD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 139.
7.4.8.3 Installing a 2.5-inch HDD/SSD module
Ê If applicable, install the HDD/SSD in the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 139.
Ê Install the HDD/SSD module, see section "Installing 2.5-inch HDD/SSD
modules" on page 182.
7.4.8.4 Concluding steps
Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see section "Performing
a RAID array rebuild" on page 113.
To Next Page
Loading...
