RX2540 M4 Upgrade and Maintenance Manual 267
Expansion cards and backup units
9.5.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For the cable plan, see chapter "Appendix B" on page 573.
9.5.3.5 Connecting a FBU to the expansion card
Ê If applicable, connect an FBU cable to the expansion card, see section
"Installing the new TFM" on page 311.
9.5.3.6 Concluding steps
Ê "Reassembling" on page 63
Ê Connect all external cables to the replaced expansion card.
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70
Ê "Enabling replaced components in the BIOS" on page 108
Ê Inform the customer about changed WWN, MAC, and SAS addresses, see
section "Looking for MAC/WWN/GUID and SAS addresses" on page 115.
Ê "Updating expansion card firmware" on page 100.
Ê "Resuming BitLocker functionality" on page 112
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 266.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing/upgrading LAN controllers" on page 119.
To Next Page
Loading...
