252 Upgrade and Maintenance Manual RX2540 M4
Expansion cards and backup units
9.4.3.1 Preliminary steps
Ê "Shutting down the server" on page 55
Ê "Disconnecting the power cord" on page 56
Ê "Getting access to the component" on page 58
Ê If applicable, remove the riser module 1, see section "Handling riser
modules" on page 71.
9.4.3.2 Removing the defective OCP module
Ê Remove the OCP module, see section "Removing the OCP module" on
page 250. The four bolts remain installed.
9.4.3.3 Installing the new OCP module
Ê Install the OCP module, see section "Removing the OCP module" on
page 250.
9.4.3.4 Concluding steps
Ê If applicable, install the riser module 1, see section "Handling riser modules"
on page 71.
Ê "Reassembling" on page 63
Ê "Connecting the power cord" on page 67
Ê "Switching on the server" on page 70
Ê Inform the customer about changed WWN and MAC addresses. For more
information, see section "Looking for MAC/WWN/GUID and SAS
addresses" on page 115.
Ê "Updating the NIC configuration file in a Linux and VMware environment" on
page 112
Ê "Configuring LAN teaming" on page 119
To Next Page
Loading...
