Siemens SINAMICS G220 - Page 352

- 2452 -
1
PROFIdrive ZSW1 status word interconnection in Interface Mode 1
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
ZSW1.0 ZSW1.1 ZSW1.2 ZSW1.3 ZSW1.4 ZSW1.5 ZSW1.6 ZSW1.8 ZSW1.9
ZSW1.11 ZSW1.12 ZSW1.13 ZSW1.14
ZSW1.7
ZSW1.10
c2053[0].2 = r0899.2 c2053[0].3 = r2139.3 c2053[0].7 = r2139.7 c2053[0].8 = r2197.7 c2053[0].9 = r0899.9
c2053[0].10 = r2199.1
c2053[0].11 = r0052.11 c2053[0].12 = r0899.12
c2053[0].0 = r0899.0 c2053[0].1 = r0899.1
[2503.7] [2548.7] [2503.7] [2503.7] [2503.7] [2548.7] [2534.7] [2503.7] [2537.7] [2510.7] [2503.7] [2503.7]
[8065] [8011] [2503] [8010]
-
[2701]
Signal
ZSW1.15
Interconnection
parameter
Meaning
[Function diagram]
signal target
[Function diagram]
internal control word
1 = Open holding brake 1 = Control requested 1 = Speed setpoint - actual value deviation within tolerance t_off 1 = I, M, or P limit not reached
1 = Alarm present
1 = f or n comparison value reached/exceeded 1 = Switching on inhibited active 1 = No Quick stop active (OFF3 inactive) 1 = No coast down active (OFF2 inactive) 1 = Fault present 1 = Operation enabled (drive follows n_set) 1 = Ready for operation (DC link loaded, pulses inhibited) 1 = Ready for switching on
<3> <2> The ZSW1 is generated using c2053[0].0...15.
c2053[0].4 = r0899.4 c2053[0].5 = r0899.5 c2053[0].6 = r0899.6
[2610] [2610] [2610] [8060] [2610] [2610] [2610]
c2053[0].15 = r2135.71 = No alarm, thermal overload, power unit
1 = No motor overtemperature alarm 1 = Motor rotates forwards (n_act ≥ 0) 0 = Motor rotates backwards (n_act < 0)
c2053[0].13 = r2135.6 c2053[0].14 = r2197.3
[2549.7] [2534.7]
[8016] [8011]
Signal sources for ZSW1 in Interface Mode 1
[2549.7] [8021] [2503.7]
The drive is ready to accept data.
<3>
<1>
<2>
Used in telegram 1, 2, 3, 4, 352.
<1>
Figure14-14 2452 – ZSW1 status word interconnection in Interface Mode 1
Functions
14.4PROFINET communication
SINAMICS G220 converter
350 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB