Siemens SINAMICS G220 - Page 354

Status word 2 (ZSW2)
Converter → Control
Bit Status
09 Telegrams 2, 3 and 4 Telegrams 110 and 111
Reserved 1 = Drive data set DDS e󹪜ective bit3
10 1 = Pulses enabled Reserved
11 1 = Motor changeover active
12 …
15
Reserved
Parameters
The following list contains the parameters of the "Control and status word 2" function.
Number Name Unit
r0051.0...3 Drive Data Set DDS e󹪜ective 
c0820[0...n] Drive Data Set selection DDS bit 0 
c0821[0...n] Drive Data Set selection DDS bit 1 
c0822[0...n] Drive Data Set selection DDS bit 2 
c0823[0...n] Drive Data Set selection DDS bit 3 
c0828[0...n] Motor changeover feedback signal 
r0835.0...10 Data set changeover status word 
r0899.0...13 Status word sequence control 
r1199.0...8 Ramp-function generator status word 
r1406.4...15 Control word speed controller 
c1477[0...n] Speed controller set integrator value 
c1545[0...n] Activates travel to a 󹪝xed stop 
c2045 PB/PN clock synchronous controller sign-of-life 
r2050[0...31].0...15 PROFIdrive PZD receive word 
r2139.0...15 Status word faults/alarms 1 
Functions
14.4PROFINET communication
SINAMICS G220 converter
352 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB