Siemens SINAMICS G220 - Page 355

- 2444 -
1
PROFIdrive STW2 control word interconnection in Interface Mode 1
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
STW2.0 STW2.1 STW2.2 STW2.3 STW2.4 STW2.5 STW2.6 STW2.8 STW2.9
STW2.11 STW2.12 STW2.13 STW2.14
STW2.7
STW2.10
c0822[0] = r2050[3].2 c0823[0] = r2050[3].3
-
c1545[0] = r2050[3].8
- -
c0828[0] = r2050[3].11
c0820[0] = r2050[3].0 c0821[0] = r2050[3].1
-
- - - - -
[2520.2]
- - - - - -
-
[8015]
- - -
Signal
STW2.15
Interconnection
parameter
Meaning
[Function diagram]
signal target
[Function diagram]
internal control word
Reserved Reserved
- - -
[8565] [8565] [8565] [8565]
- - -
Master sign-of-life, bit 3
c2045 = r2050[3] -
Reserved Reserved Reserved Master sign-of-life, bit 2 Master sign-of-life, bit 1 Master sign-of-life, bit 0 1 = Traverse to fixed endstop active Drive Data Set selection DDS bit 1 Drive Data Set selection DDS bit 0 Drive Data Set selection DDS bit 2 Drive Data Set selection DDS bit 3
= Motor changeover feedback signal
Signal targets for STW2 in Interface Mode 1
Reserved
<1>
<1>
Used in telegram 1, 2, 3, 4, 352.
Figure14-15 2444 – STW2 control word interconnection in Interface Mode 1
Functions
14.4PROFINET communication
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 353