Siemens SINAMICS G220 - Page 356

- 2454 -
1
PROFIdrive ZSW2 status word interconnection in Interface Mode 1
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
ZSW2.0 ZSW2.1 ZSW2.2 ZSW2.3 ZSW2.4 ZSW2.5 ZSW2.6 ZSW2.8 ZSW2.9
ZSW2.11 ZSW2.12 ZSW2.13 ZSW2.14
ZSW2.7
ZSW2.10
c2053[3].2 = r0051.2 c2053[3].3 = r0051.3
-
c2053[3].8 = r1406.8
-
c2053[3].10 = r0899.11
c2053[3].11 = r0835.0
c2053[3].0 = r0051.0 c2053[3].1 = r0051.1
-
- -
[2548.7] [2548.7]
-
[2520.7]
-
[2503.7]
- - -
- - -
[2610] [8575]
Signal
ZSW2.15
Interconnection
parameter
Meaning
[Function diagram]
signal target
[Function diagram]
internal control word
Follower sign-of-life, bit 0 Reserved 1 = Travel to fixed stop active 1 = Motor changeover active 1 = Pulses enabled 1 = Alarm class bit 1 1 = Alarm class bit 0 Reserved 1 = Drive Data Set, DDS effective bit 3 1 = Drive Data Set, DDS effective bit 2 1 = Drive Data Set, DDS effective bit 1 1 = Drive Data Set, DDS effective bit 0
<3> <2>
These signals are automatically interconnected for clock-cycle synchronous operation.
-
c2053[3].5 = r2139.11 c2053[3].6 = r2139.12
[8565] [8565] [8565] [8565]
-
[8065] [8065]
Follower sign-of-life, bit 3 Follower sign-of-life, bit 1 Follower sign-of-life, bit 2
-
Signal sources for ZSW2 in Interface Mode 1
-
Not for U/f control.
Implicitly interconnected
<4> <3> <4> <3> <4> <3> <4> <3> <3>
Reserved
<4>
The ZSW2 is generated using c2053[3].0...15.
<1>
<2>
Used in telegram 1, 2, 3, 4, 352.
<1>
Figure14-16 2454 – ZSW2 status word interconnection in Interface Mode 1
Functions
14.4PROFINET communication
SINAMICS G220 converter
354 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB