Siemens SINAMICS G220 - Page 524

- 2526 -
1
Internal control/status words Status word, closed-loop control (r0056)
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
Bit No. Meaning
r0056 r0056.0..15
Status word, closed-loop control
r0056.31 = Soft starting present r0056.41 = Magnetizing completed r0056.51 = Voltage boost when starting r0056.61 = Acceleration voltage r0056.71 = Frequency negative r0056.81 = Field weakening active r0056.91 = Voltage limit active r0056.101 = Slip limit active r0056.121 = Current limiting controller voltage output active r0056.141 = Vdc_max controller active
01 00 02 03 05 06 07 08 10 11 12 14 13 04 09 15
r0056.01 = Initialization completed r0056.11 = De-magnetizing completed r0056.21 = Pulse enable available r0056.111 = Frequency limit active r0056.131 = Current/torque limiting r0056.151 = Vdc_min controller active
[2701.1] [6710.6] [6832.4] [8015.1] [2510.2], [8015.1] [6710.1] [6832.4]
[6730.5], [6731.5], [6792.5] [6841.5], [6842.5], [6843.5]
[6856.5]
[6220.8], [6320.8]
[6311.8] [6715.8] [6833.8]
[6722.4], [6791.4] [6835.4], [6837.4]
[6730.5], [6731.5], [6792.5] [6841.5], [6842.5], [6843.5]
[6856.5]
[6301.3] [6851.4] [6301.3] [6722.8] [6837.8] [6850.6]
[6220.8], [6320.8]
[6031.5], [6710.3] [6822.6], [6832.4]
[6060.8], [6300.5]
[6826.8]
p0504 = 2: Dynamic Drive Control (DDC) p0504 = 1: Standard Drive Control (SDC)
Figure14-123 2526 - Status word closed-loop control
Functions
14.10Closed-loop drive control
SINAMICS G220 converter
522 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB