Siemens SINAMICS G220 - Page 525

- 2530 -
1
Internal control/status words Status word, closed-loop current control (r1408)
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
Bit No. Meaning
r1408 r1408.0..31
Status word current controller
r1408.31 = Voltage limiting active r1408.81 = iq limiting active r1408.101 = Speed adaptation limiting active r1408.111 = Speed adaptation speed deviation Out tolerance r1408.121 = Motor stalled r1408.171 = Torque limit active
01 00 02 03 08 09 10 11
13...15
17 16
04...07
12 18
r1408.01 = Current controller active r1408.11 = Id control I component limiting active r1408.161 = Current limit active r1408.181 = Power limit active
[8015.1]
Reserved Reserved Reserved Reserved
r1408.191 = Stall limit active r1408.311 = Standard Drive Control active
19
20...30
31
[6640] [6829]
[6852]
Reserved
[6714.5] [6833.5]
[6715.8] [6833.8] [6730.4] [6841.4] [6730.4] [6841.4]
[8015.1]
<1>
<1>
Stall detection or stall monitoring not available for U/f control and SDC.
<1>
p0504 = 2: Dynamic Drive Control (DDC)
p0504 = 1: Standard Drive Control (SDC)
Figure14-124 2530 - Status word closed-loop current control
Functions
14.10Closed-loop drive control
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 523