Siemens SINAMICS G220 - Page 588

Example
%SJWF
GVODUJPOT
"DLOPXMFEHF
4FMFDUDPNNBOEEBUBTFU
$%4
$PNNBOEEBUBTFU
1BSBNFUFSJOEFY<>
$PNNBOEEBUBTFU
1BSBNFUFSJOEFY<>
+PH
+PH
"DLOPXMFEHF
$POUSPMCZ1-$
.01MPXFS
0/0''
%BUBGSPN
꫼FMECVT
S
D<>
S
D<>
S
D<>
S
D<>
S
D<>
S
D<>
S
D<>
S
D
















%*
%*
%*
%*
1;%
1;%
1;%
1;%
1;%
1;%
1;%
1;%
Figure14-178 Switching command data sets
The motor should be controlled either from a central control via the 󹪝eldbus or locally via the
digital inputs of the converter.
Digital input DI3 switches the command data set and hence the control commands.
Parameters
The following list contains the parameters of the "Switching between drive controls" function.
Number Name Unit
r0050.0...1 Command Data Set CDS e󹪜ective 
p0170 Number of Command Data Sets (CDS) 
c0810 Command data set selection CDS bit 0 
c0811 Command data set selection CDS bit 1 
Functions
14.11Drive functions
SINAMICS G220 converter
586 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB