RM0090 USB on-the-go high-speed (OTG_HS)
Doc ID 018909 Rev 4 1178/1422
wide, and the addresses are 32-bit block aligned. The OTG_HS registers must be accessed
by words (32 bits). CSRs are classified as follows:
● Core global registers
● Host-mode registers
● Host global registers
● Host port CSRs
● Host channel-specific registers
● Device-mode registers
● Device global registers
● Device endpoint-specific registers
● Power and clock-gating registers
● Data FIFO (DFIFO) access registers
Only the Core global, Power and clock-gating, Data FIFO access, and host port control and
status registers can be accessed in both host and peripheral modes. When the OTG_HS
controller is operating in one mode, either peripheral or host, the application must not
access registers from the other mode. If an illegal access occurs, a mode mismatch
interrupt is generated and reflected in the Core interrupt register (MMIS bit in the
OTG_HS_GINTSTS register). When the core switches from one mode to the other, the
registers in the new mode of operation must be reprogrammed as they would be after a
power-on reset.
To Next Page
Loading...
Need help?
General
