ST STM32F40 Series User Manual

RM0090 Real-time clock (RTC)
Doc ID 018909 Rev 4 626/1422
23.2 RTC main features
The RTC unit main features are the following (see Figure 222: RTC block diagram):
● Calendar with subseconds , seconds, minutes, hours (12 or 24 format), day (day of
week), date (day of month), month, and year.
● Daylight saving compensation programmable by software.
● Two programmable alarms with interrupt function. The alarms can be triggered by any
combination of the calendar fields.
● Automatic wakeup unit generating a periodic flag that triggers an automatic wakeup
interrupt.
● Reference clock detection: a more precise second source clock (50 or 60 Hz) can be
used to enhance the calendar precision.
● Accurate synchronization with an external clock using the subsecond shift feature.
● Maskable interrupts/events:
–Alarm A
–Alarm B
– Wakeup interrupt
–Timestamp
– Tamper detection
● Digital calibration circuit (periodic counter correction)
– 5 ppm accuracy
– 0.95 ppm accuracy, obtained in a calibration window of several seconds
● Timestamp function for event saving (1 event)
● Tamper detection:
– 2 tamper events with configurable filter and internal pull-up.
● 20 backup registers (80 bytes). The backup registers are reset when a tamper
detection event occurs.
● Alternate function output (RTC_OUT) which selects one of the following two outputs:
– RTC_CALIB: 512 Hz or 1 Hz clock output (with an LSE frequency of 32.768 kHz).
This output is enabled by setting the COE[23] bit in the RTC_CR register. It is
routed to the device RTC_AF1 function.
– RTC_ALARM (Alarm A, Alarm B or wakeup).
This output is selected by configuring the OSEL[1:0] bits in the RTC_CR register.
It is routed to the device RTC_AF1 function.
● RTC alternate function inputs:
– RTC_TS: timestamp event detection. It is routed to the device RTC_AF1 and
RTC_AF2 functions.
– RTC_TAMP1: TAMPER1 event detection. It is routed to the device RTC_AF1 and
RTC_AF2 functions.
– RTC_TAMP2: TAMPER2 event detection.
– RTC_REFIN: reference clock input (usually the mains, 50 or 60 Hz).
Refer to Section 7.3.15: Selection of RTC_AF1 and RTC_AF2 alternate functions.

ST STM32F40 Series Specifications

General

Brand	ST
Model	STM32F40 Series
Category	Microcontrollers
Language	English