USB on-the-go high-speed (OTG_HS) RM0090
1161/1422 Doc ID 018909 Rev 4
31.2.2 Host-mode features
The OTG_HS interface features in host mode are the following:
● It requires an external charge pump to generate V
BUS
●
It has up to 12 host channels (pipes), each channel being dynamically reconfigurable to
support any kind of USB transfer
● It features a built-in hardware scheduler holding:
– Up to 8 interrupt plus isochronous transfer requests in the periodic hardware
queue
– Up to 8 control plus bulk transfer requests in the nonperiodic hardware queue
● It manages a shared RX FIFO, a periodic TX FIFO, and a nonperiodic TX FIFO for
efficient usage of the USB data RAM
● It features dynamic trimming capability of SOF framing period in host mode.
31.2.3 Peripheral-mode features
The OTG_HS interface main features in peripheral mode are the following:
● It has 1 bidirectional control endpoint 0
● It has 5 IN endpoints (EP) configurable to support bulk, interrupt or isochronous
transfers
● It has 5 OUT endpoints configurable to support bulk, interrupt or isochronous transfers
● It manages a shared Rx FIFO and a Tx-OUT FIFO for efficient usage of the USB data
RAM
● It manages up to 6 dedicated Tx-IN FIFOs (one for each IN-configured EP) to reduce
the application load
● It features soft disconnect capability
To Next Page
Loading...
Need help?
General
