ELECTRICAL SAFETY
General Guidelines
Warning: Read the following warnings.
• Do not push objects into slots or openings on the press. Touching a voltage point or shorting out a part could
result in fire or electric shock.
• Do not remove the covers or guards that are fastened with screws unless you are installing optional equipment
and are instructed to do so. Switch off the press when performing these installations. Disconnect the power cord
when removing covers and guards for installing optional equipment. Except for user-installable options, there
are no parts that you can maintain or service behind these covers.
Emergency Power Off
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the press.
• The press is exposed to water.
• The press emits smoke, or the surface is unusually hot.
• The press emits unusual noise or odors.
• The press causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
Power Cable and Electrical Supply
• Use the power cords that are supplied with your press.
• Do not remove or modify the power cord.
• The electrical outlet must be near the printer and must be easily accessible.
• Plug the power cable directly into a properly grounded electrical outlet. Ensure that each end of the cable is
connected securely. If you do not know if an outlet is grounded, ask an electrician to check the outlet.
Warning: To avoid risk of fire or electrical shock, do not use extension cords, power strips, or power
plugs. Always adhere to national and local building, fire, and electrical codes regarding length of cord,
conductor size, grounding, and protection.
• Do not use a ground adapter plug to connect the press to an electrical outlet that does not have a ground
connection terminal.
12
Xerox
®
Versant
®
280 Press User Documentation
Learning About
To Next Page
Loading...
Need help?
General
