OPERATIONAL SAFETY
Your Xerox equipment and supplies were designed and tested to meet strict safety requirements. These include
safety agency examination, approval, and compliance with established environmental standards.
Your attention to the following safety guidelines will help ensure the continued safe operation of your Press:
• Do not remove any trays when the Press is printing.
• Do not open the doors when the Press is printing.
• Keep hands, hair, neckties, and so on, away from the exit and feed rollers.
• Covers, which require tools for removal, protect the hazard areas within the Press. Do not remove the protective
covers.
• Do not attempt to remove paper that is jammed deeply inside the Press. Switch off the Press promptly and
contact your local Xerox representative.
• To avoid a tip hazard, do not push or move the device with all of the paper trays extended.
• Do not place the Press in locations susceptible to vibrations.
• For optimum performance, use the Press at the Altitude specified in Environmental Specifications section of the
User Documentation.
• Use the materials and supplies specifically designed for your Press. The use of unsuitable materials may result in
poor performance of the Press and possibly a hazardous situation.
• Follow all warnings and instructions that are marked on or supplied with the Press.
• Place the Press in a room that provides adequate space for ventilation and servicing.
• Place the Press on a level, solid surface, not on a thick pile carpet, that has adequate strength to support the
weight of the Press.
• Do not attempt to move the Press. A leveling device that was lowered when your Press was installed may
damage the carpet or floor.
• Do not set up the Press near a heat source.
• Do not set up the Press in direct sunlight.
• Do not store or operate the Press in an extremely hot, cold, or humid environment.
• Do not set up the Press in line with the cold air flow from an air conditioning system.
• Do not place containers of coffee or other liquid on the Press.
• Do not block or cover the slots and openings on the Press.
• Do not attempt to override any electrical or mechanical interlock devices.
WARNING—HOT SURFACE: Be careful when working in areas identified with this warning symbol.
These areas may be very hot and should not be touched.
If you need any additional safety information concerning the Press or materials, contact your Xerox representative.
14
Xerox
®
Versant
®
280 Press User Documentation
Learning About
To Next Page
Loading...
Need help?
General
