6. Push the Saddle Stitch Unit 3 gently into the finisher until it stops.
7. Close the finisher front cover.
Stapler Faults in the PR Finisher Plus
Refer to the following procedures for clearing staple jams the PR Finisher Plus, Basic Staple Cartridge:
• Finisher Staple Faults
• Clearing Staple Jams in the Basic Stapler
• Reinserting the Basic Staple Cartridge
Finisher Fault Messages
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops printing and
a message appears on the press touch screen. A graphical illustration shows the location of the fault with a brief
explanation of corrective actions for clearing the fault. If a fault occurs in more than one location, the illustration
changes to indicate the multiple locations and the required corrective actions.
The touch screen also displays a Faults button which provides information about the fault and detailed instructions
for correcting the fault. The (EE) code on the upper-left part of the Fault message displays which error indicator is lit
on the Finisher indicator panel (E1–E9).
Finisher Fault Code Information
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops printing and
a message appears on the press touch screen.
The touch screen also displays a Faults button which provides information about the fault and detailed instructions
for correcting the fault.
Tip: Finisher faults are identified by the codes which start with the three-digit numbers 001122, 001133, 002244, 004411, 111122,
and 112244.
Xerox
®
Versant
®
280 Press User Documentation 417
Troubleshooting
To Next Page
Loading...
Need help?
General
