Xerox Versant 280 - Crease and Two-Sided Trimmer; Crease and Two-Sided Trimmer Components

• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require 330 mm (13 in.)
minimum measurement in the feed direction.
CREASE AND TWO-SIDED TRIMMER
Note: This optional finishing device requires the Interface Decurler Module.
The Crease and Two-Sided Trimmer is an optional finishing device that provides trimming on two sides of the
output.
• Trims 6–25 mm (0.24–0.99 in.) from the top and bottom of prints or booklets to produce an even edge.
• When paired with the SquareFold
®
Trimmer, all sides of booklets are trimmed except the binding, which enables
full-bleed booklets. For more information, refer to SquareFold Trimmer Device.
• Trims paper sizes 182 x 257–330 x 488 mm (7.2 x 10.1–3 x 19.2 in.). If the trimmed output is for booklet
making, the minimum paper size is 194 x 257 mm (7.6 x 10.1 in.).
• Handles uncoated and coated paper 52–350 g/m
2
.
Crease and Two-Sided Trimmer Components
192 Xerox
®
Versant
®
280 Press User Documentation
Working With