4. Select the specific profile that you want to use. You need to use the up or down arrows to locate it.
5. Touch Save.
6. Touch Save again.
7. Touch Confirm.
The custom fold profile is now associated with the tray and is used for any paper in the tray.
Note: You can assign the profile to a Custom Paper, then assign the Custom Paper to the tray. It is useful if
there are other adjustments, such as paper curl, alignment, or print engine adjustments that you want to
apply to the paper you are using for the booklets, in addition to the fold adjustment settings.
PRODUCING SIMPLE FOLDED SHEETS AND INSERTING FOLDED SHEETS INTO A DOCUMENT
Use the Production Ready (PR) Finisher, Basic Punch, and C/Z Folder to produce simple folded sheets or insert folded
sheets into a document.
With the optional C/Z Folder, you can produce C and Z folds on 8.5 x 11 in. or A4 sheets. You also can create
engineering Z-folds on 11 x 17 in. or A3/B4 media. These Z-folds are called Half Z-folds. The engineering Z-fold or
Half Z-fold folds the 11 x 17 in. or A3/B4 paper and reduces the sheet to 8.5 x 11 in. or A4 paper, respectively. This
process allows you to insert the folded sheet into an 8.5 x 11 in. or A4 document so that the reader can pull out the
folded portion to see an extra-large image.
C-Fold or Trifold
Z-fold Half Z-fold or Engineering Z-fold
Important: When you load or select media for folding, position the paper Short Edge Feed (SEF).
Note: Each Z-Fold Half Sheet added to a stapled set counts as 10 sheets. It reduces the total number of
sheets for any given specified weight range.
Producing Simple Folded Sheets with the EX Print Servers
1. For the job, load the paper short-edge feed (SEF) into a tray and program the media at the press User
Interface (UI).
2. Submit the job to the print server Hold queue.
3. From the print server, to open the job, double-click the Properties.
4. Set all required properties for the job such as quantity, paper size, source tray, and 1-sided or 2-sided.
5. Select one of the following:
• For C and Z-folds, use 8.5 x 11 in. or A4 sheets.
• For Engineering Z-fold or Half Z-fold, use 11 x 17 in. or A3/B4 paper.
Xerox
®
Versant
®
280 Press User Documentation 225
Working With
To Next Page
Loading...
Need help?
General
