Xerox Versant 280 - Streaks or Lines on Prints

SSoolluuttiioonnss
Acquire the measuring tool either from www.xerox.com/VERSANT_280docs or the Nationalization Kit. Check the
frequency of the defect interval.
• If the defect occurs every 44 mm on the prints, do not replace the drum. This interval is caused by a damaged
or defective developer housing. For more details, contact the Customer Support Center.
• If spots or bands occur every 147 mm on the prints, a drum is damaged or light shocked. Replace or swap the
appropriate drum cartridge; refer to Replacing a Drum Cartridge.
• If the defect occurs every 374 mm on the prints, replace the fuser belt assembly. For details, contact the
Customer Support Center.
STREAKS OR LINES ON PRINTS
PPrroobblleemm
The prints show solid color streaks or lines running from Lead Edge to Trail Edge (LE or TE) of prints.
288
Xerox
®
Versant
®
280 Press User Documentation
Troubleshooting