– Tray 5 (Bypass) Extra Long Sheet, 1-sided: 330.2 x 660 mm (13.0 x 26.0 in.)
– Trays 6, 7 (optional Advanced Oversized High Capacity Feeder): 330.2 x 488 mm (13.0 x 19.2 in.)
PPrriinnttiinngg RReessoolluuttiioonn
• Print Engine Imaging Resolution: 2400 x 2400 dpi
• Print Server RIP Resolution (print server to print engine): 1200 x 1200 dpi
FIRST-PRINT-OUT TIME
First Print-Out Time is measured from the time that the printer starts to the time the trailing edge of the sheet exits
the Offset Catch Tray.
Note: If the system is equipped with various types of finishing devices, the First-Print-Out Time varies
depending on the length of the paper path required to transport that paper.
• From a cold start (power on or power saver), the system takes less than 5 minutes to start printing.
• From standby mode, the system usually takes less than 1 minute to start printing.
• In Ready Mode, on average, the First-Print-Out Time is less than 8 seconds for color and less than 10 seconds for
black and white.
• When you copy or print during initial power on, the system requires 30–45 seconds to produce the first print.
• Switching from a color mode job to a black and white job or the reverse requires on average 30–60 seconds.
• 60 seconds is needed after a paper jam. to ensure that the system is recovered from possible contamination,
and to ensure that the image quality is optimized.
PRESS WARM-UP TIME
The press warm-up times vary depending on the current state or mode of the press. Warm-up times are listed as
follows:
• From a cold start (power on or power saver mode), less than 5 minutes
• From Sleep Mode or Power Saver, less than 5 minutes
• From Standby Mode, less than 1 minute
• When switching print modes (such as from black only to full color), approximately 2 minutes
28
Xerox
®
Versant
®
280 Press User Documentation
Learning About
To Next Page
Loading...
Need help?
General
