5. Load and register the paper against the right side of the tray for LEF direction.
6. Load and register the paper against the right side of the tray as depicted below for SEF direction.
7. Adjust the paper guides by pressing in the guide release and carefully moving the Edge Guide until it lightly
touches the edge of the stock in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
8. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings/Tray Properties window displays on the UI.
9. From the Paper Tray settings/Tray Properties window, enter the correct paper information, including size, type,
weight and, if necessary, paper curl and alignment option.
10. Select Confirm or OK to save the information and close the Paper Tray settings/Tray Properties window.
Skew Adjustment Levers for Trays 8 and 9
For information and instructions on using the skew adjustment levers for trays 8 and 9, refer to Skew Adjustment
Levers for Trays 6-9.
Xerox
®
Versant
®
280 Press User Documentation 143
Working With
To Next Page
Loading...
Need help?
General
