• Finisher Consumable Supplies
• Checking the Status of Finisher Consumables
• Replacing the Basic Staple Cartridge (for Side Stitching)
• Replacing the Finisher Staple Waste Container
• Emptying the Hole Punch Waste Container
SquareFold
®
Trimmer Device Maintenance
Emptying the SquareFold
®
Trimmer Waste Container
When the waste container reaches the full condition, an indicator lights on the top of the SquareFold
®
Trimmer
device. A message also appears on the press indicating that it is full. When the message appears, dispose of the
paper scraps.
Note: Keep the press powered on when disposing of the waste. If powered off, the press does not recognize
that the container was emptied.
Perform the following steps to empty the trimmer waste container.
1. Ensure that the press is not running, then slowly pull out the Trimmer Waste Container.
270 Xerox
®
Versant
®
280 Press User Documentation
Working With